-Origami Rose Ring Tutorial
This is a very simple diy jewelry project, you can use a piece of square paper (length and width 4*4CM) to make a rose, and then use a small rectangular piece of paper to make a ring, and then glue the rose and the ring together. After the ring is ready, you can use it for your daily wear, or give it to your friends or relatives as a gift.
Here are the steps to make this ring.
1：Choose a square paper, fold it in half along the two diagonals, then fold it in half again along the center line, then open the paper and press the center line crease inward.
2：After pressing out a triangle, follow step 8 to fold up a small triangle. Then fold out a small triangle on the left side, open the small triangle and press down and fold out a square. The same steps are done on the left.
3：Turn the upper side of the small square on the right side out and fold it into a triangle. Then fold the left side into a triangle as well. Then fold up a triangle along the dotted line in step 14. Turn over to the other side and repeat steps 8 to 15.Then turn to the side next to it.
4：Turn over this side, then fold in half along the center line to form a small triangle, and do the same to form a triangle on the left side. Fold up a triangle at the bottom as well. Then turn to the other side and repeat steps 20-22.
5：Then go to the bottom and open the bottom that was circled with a dotted circle in step 25. Then flip to the other end (rotate 180 degrees on the basis of step 26), grab the middle bud and turn inward, press the petals outward, and then roll it up. This completes the rose flower.
6：Then cut a strip of paper according to the size of your finger, fold it in half, roll it into a circle, and fix it with glue. Finally glue the roses to the ring. This completes the origami rose ring.
